Contact Us

Nanjing Kingmore Logistics Equipment Manufacturing Co.,Ltd
Factor 1: No.8 Xingfu Ave. Hengxi St., Jiangning, Nanjing, China
Factor 2: No.896 Jianshe Road West, Economic Development Zone, Jinhu County, China
Tel: +86-25-86154259
Fax: +86-25-86154259
Mob: +8613512517514

The Requirements For Warehouse Floor For Warehouse Planning

- Feb 03, 2019 -

AS/RS racking system requires that the warehouse floor be very flat and suitable for fast forklift transport or other equipment operation. Super flat is less used, suitable for storage that rarely allows vibration, such as the TV recording industry. For example, the general storage floor requirements are FF30/FL25, and some narrow passage VNA areas have higher floor requirements, such as FF60 / FL50. At present, the construction party often adopts the epoxy self-leveling floor technology, which automatically leveles the ground and has multiple colors. Although there is no standard for logistics storage floors in China, and American standards are still being used, more and more cases prove that the storage floor is an important part that cannot be ignored from design to construction, and will be used in the future. Maintenance puts forward higher requirements.

Only the surface water level that meets the requirements can ensure that the verticality and level of the storage shelves meet the installation requirements after the installation of the storage shelves. When the level of the building does not meet the standard, the shelf will be tilted, and side torque will be generated at the bottom of the shelf, which will cause hidden dangers to the safe use of the shelf. The most serious consequence will be the collapse of the warehouse shelves.

Shelf requirements for warehouse buildings:

1. Warehouse buildings must meet the basic requirements of ventilation, lighting, fire protection, and smooth logistics;

2. Requirements for warehouse floor to warehouse floor:

Before the warehouse shelves are installed, the allowable deviation of the ground flatness shall comply with the following table.

Length and width dimensions (m) allowable deviation (mm)

Less than or equal to 50 ± 10

Less than or equal to 150 ± 15

More than 150 ± 20.

Related Products